![]() ![]() On reconnection, an address other than the preferred IP address (if specified) may be assigned to the PPPoE connection. To prevent reconnection during working hours, turn on the PPPoE reconnect schedule. When the period expires, the PPPoE connection is closed and reconnected. The IP address assigned to a PPPoE connection, whether dynamic or static (preferred), can have a predefined validity period. It only resets the number of echo request attempts to the default value (3). Note: Clearing the checkbox doesn't turn off LCP. If the firewall doesn't receive a reply from the client after these requests, it disconnects the PPPoE connection. Select this option only if you want to change the default number of echo requests, then enter the value. It only resets the interval to the default value (20 seconds). The firewall sends echo requests at these intervals to check whether the link is live. Select this option only if you want to change the default value, then enter the value. The firewall starts only those sessions with the access concentrator that can provide the specified service. The name of the gateway through which you want to route the internet traffic.Īccess concentrator and service name. ![]() Sophos Firewall allows you to bind the static IP address to the PPPoE connection.ĭepending on the PPPoE server configuration, an IP address other than the preferred IP address may be assigned to the PPPoE connection. Many internet service providers assign a static IP address to PPPoE connections. Preferred IP address for the PPPoE connection. If you're configuring a PPPoE interface, you must enter the following information as provided by your ISP. If you're setting up a WAN interface, you must also enter the name of your gateway and its IP address. IP Address of the Sophos XG Firewall is required. ![]() To assign a static IP address to the interface, enter the IP address you want to use and the network's subnet mask. Go to Rules and policies > Firewall rules > Add firewall rule > New firewall rule. This Guide describes CLI commands used to configure and manage a Sophos XG. See the next step to set a static IP address for the interface. You must enter the information provided by your ISP. PPPoE connection is normally only used in the WAN zone when setting up a DSL connection to your ISP. If you choose DHCP, no further configuration options are required, and you can save the configuration. Users can also customize settings so they can choose which IP addresses. Select how the interface IP address will be assigned. (Image credit: Sophos) 3 Sophos FirewallDedicated cloud securityTodays Best. When a zone is chosen, further configuration options are shown. Select a zone from the Network zone list. To configure an interface, do as follows: Your browser doesn’t support copying the link to the clipboard. It will remain unchanged in future help versions. Always use the following when referencing this page. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |